Home› Trading Cards & Memorabilia Forum
Options

GAI 2 Ruth Goudey #144 cross to psa?

reggiejax44reggiejax44 Posts: 21
in Trading Cards & Memorabilia Forum
Hello,

I just won the following Ebay auction and am planning on sending this to PSA as a cross. Should I leave it in the GAI holder and ask for a minimum grade of 2, or crack it and submit to PSA. Thye last thing that I want to happen would be to crack and PSA not grade it!

Any suggestions or thoughts would be very much appreciated.

I tried to link the auction, but could not figure out how to do it. The Ebay item# is 5240716414 .

Comments

  • Options
    packCollectorpackCollector Posts: 2,786 ✭✭✭
    didn't even look at the card but crack it , you have no chance in the gai holder of crossing it, ok maybe .001% chance
  • Options
    reggiejax44reggiejax44 Posts: 21
    Do you think there is a chance that PSA won't grade it after I crack it. Trimmed, not authentic, etc..

    Also, what is the best way to crack the holder without destroying the card?
  • Options
    AllenAllen Posts: 7,167 ✭✭✭
    That card looks almost too clean as far as surface and paper loss etc....

    Auction Link

    image
  • Options
    reggiejax44reggiejax44 Posts: 21
    Thanks for linking it. I am assuming that this card has creases. The seller stated that it had no writing on it, just normal wear for a 72 year old card.
  • Options
    packCollectorpackCollector Posts: 2,786 ✭✭✭
    I wouldn't worry about authenticity , I would think you would be safe on trimming but you never know no matter whose holder you crack. PSA tends to be cautious and it is not uncommon for a card to graded once and evid trim another. on a low grade card with this thpe of wear , I would not think it's trimmed . just my opinion, the final risk is yours.
  • Options
    reggiejax44reggiejax44 Posts: 21
    If I decide to, what is the best way to crack?
  • Options
    EagleEyeKidEagleEyeKid Posts: 4,496 ✭✭
    Pliers usually do the job. Just break the top or corner area (take a rip or chunk with the pliers). Remember to always keep a steady hand and watch out for flying pieces of plastic debris (usually occurs with BGS holders). Once you get an opening on the top, you can use a flat head screwdriver to get in between the sandwich and just move it up and down with the screwdriver and go along the entire edge of the holder.....again, steady hand and take your time. If you slip with the screwdriver, you may slide it towards the card and add a nice long streak of surface damage or whatever. Good luck.
  • Options
    reggiejax44reggiejax44 Posts: 21
    Hello Again,

    Do you guys think $875.00 is a fair price for this card. I have wanted this card for a long time. Also, I should add that I kind of took a little risk because I have not seen the back of the card.
  • Options
    MuckyMuttMuckyMutt Posts: 803
    reggiejax44,
    the auction ended yesterday and you didn't get it - even at $875. While I was looking at the auction, does anybody else think that bidder lou-al might have been a shill? He's got a feedback of 1 for some stinkin perfume he bought!?! crazy...
    << image >>
  • Options
    reggiejax44reggiejax44 Posts: 21
    Hello,

    Yeah I saw that bidder. Could possibly be a shill I guess. Other people bid higher than him though. Also, I actually did win the auction. I am srg4lucky on Ebay. I couldn't really understand what you meant by the auction ended and I didn't even get it?
  • Options
    MuckyMuttMuckyMutt Posts: 803


    << <i>I couldn't really understand what you meant by the auction ended and I didn't even get it? >>



    Oooops, I saw the second high bid of $875, thought you got sniped out at $878.58. Sorry.
    << image >>
Sign In or Register to comment.