Home› U.S. Coin Forum
Options

Just added this neat Seated Half Dime Variety to my Variety Type set Showcase.

DIMEMANDIMEMAN Posts: 22,403 ✭✭✭✭✭

I have been looking for one of these for a long time. It is hard to find nice Half Dimes that show good detail without getting super high MS coins it seems. But I found this nice AU53 on Brian Greers site. It shows the repunched date very well. Thanks for looking and comments welcome.

Comments

  • Options
    JimnightJimnight Posts: 10,845 ✭✭✭✭✭

    Very nice coin with beautiful toning.

  • Options
    rickoricko Posts: 98,721 ✭✭✭✭✭

    Very nice Jon... Thanks for the enlargement, it is clear. Cheers, RickO

  • Options
    astroratastrorat Posts: 9,221 ✭✭✭✭✭

    Nice coin!

    Brian has great stuff and very reasonable prices.

    Numismatist Ordinaire
    See http://www.doubledimes.com for a free online reference for US twenty-cent pieces
  • Options
    ms70ms70 Posts: 13,957 ✭✭✭✭✭

    That's a nice example. Brian has nice stuff. Some of my favorite pieces are from him.

  • Options
    KkathylKkathyl Posts: 3,762 ✭✭✭✭✭

    Really cool over inverted date. Wow. Great addition 😎

    Best place to buy !
    Bronze Associate member

  • Options
    yosclimberyosclimber Posts: 5,343 ✭✭✭✭✭
    edited December 5, 2019 1:37PM

    It's a classic!

    Here's what @MrHalfDime wrote about this variety in 2007:

    For the early (Flowing Hair and Draped Bust) half dimes, the date numerals were individually punched into the working dies by hand, one at a time. This method of hand punching the date numerals individually into the working dies continued for the Capped Bust half dimes of 1829 - 1837, as well. When Christian Gobrecht's beautiful Liberty Seated design was introduced, in 1837, not only was the same method continued for dating the obverse dies, but the very same numeral punches were also retained, as the so-called "Large Date" numeral punches of 1837. Later in that year, new date numeral punches were fabricated (the so-called "Small Date" numeral punches of 1837), but the method of dating the obverse dies by punching the date numerals individually into the working dies persisted.
    Much has been written, or perhaps speculated, about the possible use of a multi-digit gang punch, or logotype, which allowed the die sinker to combine several date numerals into one tool, and punch them into the obverse die in one motion. To my knowledge, no one living today has ever seen such a device, but many are convinced that such a device must have been used based purely upon circumstantial evidence. And there is perhaps no greater 'circumstantial' evidence of the use of such a device than the spectacular "1858 Over Inverted Date" half dime. The "1858 Over Inverted Date" variety, apparently discovered by Jesse Patrick around 1963, exhibits very strong evidence of repunching on all four digits of the date. What makes this variety particularly interesting is that the first-struck digits, or under-digits, were all struck into the die upside down. It is highly improbable that the die sinker could or would have made such a spectacular blunder if he were punching the date numerals individually. The fact that all four under-digits appear inverted strongly suggests the use of a gang punch incorporating the four digits into one tool. Apparently, after noting the error, the die sinker lapped the exergue to remove as much evidence of the digits as possible, and then punched them once again making certain to orient them upright this time. What results is a spectacular blunder on which, at least for early die states, all four under-digits are plainly evident, appearing upside down under the properly oriented digits. It is important to note, also, that for the "1858 Over Inverted Date" variety, the inverted under-digits appear in between the final digits.
    Sometime after the "1858 Over Inverted Date" variety was discovered, a new and distinctly different variety was discovered for the same date ( 1858 ) which also exhibits a repunched date, and which also strongly suggests the use of a four digit gang punch. For this new variety, the date was also strongly repunched, but on this new variety the first-struck digits were punched right-side-up, but were merely punched too high (too close to the base of the rock). The die sinker again realized the blunder, lapped the die, and repunched the date numerals a second time in the proper position. For this variety, the under-digits can be seen within and underneath the final digits, rather than in between the final digits, as on the previous variety.
    The "1858 Over Inverted Date" variety has been designated as V-9, continuing with the Valentine numbering sequence, and the "1858 Doubled Date" variety has been designated as V-10. They were previously numbered B-9 and B-10, respectively, by Walter Breen.
    It is important to note that for each of these obverse dies, the exact spacing and inter-relationship of the four digits of the date remain precisely the same for both the under-digits and for the final digits - a relationship that could not occur had a gang punch not been employed.
    It has been suggested by others that the "1858 Doubled Date" V-10 is approximately ten times as scarce as the "1858 Over Inverted Date" V-9, and this approximate rarity relationship has held up over time. The V-9 Inverted Date variety is available with only a little searching, but the obverse die is extremely weakly struck, leading people to undergrade it. Consequently, high grade (AU and MS) examples are infrequently seen.
    Certainly 1858 was not the first year in which a gang punch was used to punch the date numerals into the working dies, but it does offer some of the most convincing proof that such a tool was utilized. During the 1840s there are several examples that suggest the use of a three digit gang punch for the first three digits of the date, followed by a single numeral punch for the final digit (1848/7/6, 1848/8/7, 1849/6, 1849/8, etc.).

  • Options
    oih82w8oih82w8 Posts: 13,344 ✭✭✭✭✭

    Nice acquisition Jon!

    oih82w8 = Oh I Hate To Wait _defectus patientia_aka...Dr. Defecto - Curator of RMO's

    BST transactions: dbldie55, jayPem, 78saen, UltraHighRelief, nibanny, liefgold, FallGuy, lkeigwin, mbogoman, Sandman70gt, keets, joeykoins, ianrussell (@GC), EagleEye, ThePennyLady, GRANDAM, Ilikecolor, Gluggo, okiedude, Voyageur, LJenkins11, fastfreddie, ms70, pursuitofliberty, ZoidMeister,Coin Finder, GotTheBug, edwardjulio, Coinnmore, Nickpatton, Namvet69,...
  • Options
    ParadisefoundParadisefound Posts: 8,623 ✭✭✭✭✭

    How do you manage to get one NICE addition each and every week? May I go along with you?
    Congrats @DIMEMAN for another fine find :)

  • Options
    WalkerfanWalkerfan Posts: 10,447 ✭✭✭✭✭

    I like that one.

    Very nice addition.

    Sometimes, it’s better to be LUCKY than good. 🍀 🍺👍

    My Full Walker Registry Set (1916-1947):

    https://www.ngccoin.com/registry/competitive-sets/16292/

  • Options
    DIMEMANDIMEMAN Posts: 22,403 ✭✭✭✭✭

    @Paradisefound said:
    How do you manage to get one NICE addition each and every week? May I go along with you?
    Congrats @DIMEMAN for another fine find :)

    Come on over to the main land PF. You can go coin hunting with me any time. B) The FUN Show is coming up. You would love that show. :)

  • Options
    ashelandasheland Posts: 24,549 ✭✭✭✭✭

    Nice half dime!

  • Options
    yosclimberyosclimber Posts: 5,343 ✭✭✭✭✭
    edited December 6, 2019 2:23PM

    Your coin (and photo) shows the inverted date very well.

    Here is an early die state MS-64 which shows only slightly more detail. [PCGS CoinFacts photo]

    Your coin has a reverse clash line through "TATES O",
    plus reverse cracks at E1 (UNITED) and E2 (STATES).
    It appears that most V-9s are in this middle die state (V-9a).


    In the latest die state I've seen (V-9b), this clash line is stronger.


    V-9b also has a crack from the 1 in the date to the left.

Leave a Comment

BoldItalicStrikethroughOrdered listUnordered list
Emoji
Image
Align leftAlign centerAlign rightToggle HTML viewToggle full pageToggle lights
Drop image/file