Options
How?
ajaan
Posts: 18,108 ✭✭✭✭✭
Wear? Strike? Acid? 4.34g

DPOTD-3
'Emancipate yourselves from mental slavery'
CU #3245 B.N.A. #428
Don
1
Comments
PMD
I found one on the beach once that was similar....sandblasted through time.
I'm surprised there's not a barnacle on it.
Very interesting effect. But, you can tell that the detail was stuck up properly at one time, as there is still enough relative relief to indicate that.
'Buffed'
Does look like the texture of 'sea glass'
Successful transactions with : MICHAELDIXON, Manorcourtman, Bochiman, bolivarshagnasty, AUandAG, onlyroosies, chumley, Weiss, jdimmick, BAJJERFAN, gene1978, TJM965, Smittys, GRANDAM, JTHawaii, mainejoe, softparade, derryb, Ricko
Bad transactions with : nobody to date
Definitely PMD....several possible causes... Cheers, RickO
Thanks. I guess I'll release it back into the wild.
DPOTD-3
'Emancipate yourselves from mental slavery'
CU #3245 B.N.A. #428
Don
Interesting, but looked artificial to me. (the wear)
My YouTube Channel
What does the edge look like?
Collector, occasional seller
Sort of, but smoother. The sand and salt eats away at the metal, and if left on the beach too long, the details are erased and the coin gets thinner and thinner.
Like that of a nickel.
DPOTD-3
'Emancipate yourselves from mental slavery'
CU #3245 B.N.A. #428
Don
What gives me pause is the still mostly defined rim. I would think that whatever removed material from the faces would also remove it from the edge, rounding it off, if it was a chemical. I'd keep it as a curiosity.
Collector, occasional seller
Look at the rims - most of the rim IS removed,
except from about 7:00 to 12:00 on the obverse.
The other portions of the rim have been removed
from the buffing (not acid, in my opinion)
The Buffing also took off the .7th of a gram of metal.
NO Fred...............It is NOT a Bufftalo Nickel.
Pete
I used to work at a casting place and there were these huge vibrator bins that the castings would be placed in to knock off the rough edges. The stones in the machines were conical and not overly rough, like a very fine sandpaper. Anyway you could take a metal object, stick some tape on it and toss it in the vibrator and after a while the non taped areas would be much smoother while the taped area would be almost like new.
K