Home U.S. Coin Forum
Options

Opening 1976 3 piece silver proof set capsules

DatentypeDatentype Posts: 1,677 ✭✭✭

Does anyone know of the best way to get 1976 silver proof Washington, Kennedy and IKE silver proof coins out of the original capsules from the mint without damaging coins? Is there a tool that used?

Comments

  • Options
    AUandAGAUandAG Posts: 25,039 ✭✭✭✭✭

    Pocket knife or sharp blade to put in the crack between the halves. Pry slowly and don't slice your thumb or finger. I just tried it on the quarter in the set and was unable to follow my own directions....maybe I'll try a hammer next!

    bob:(

    Registry: CC lowballs (boblindstrom), bobinvegas1989@yahoo.com
  • Options
    JRoccoJRocco Posts: 14,277 ✭✭✭✭✭

    Put the capsule on it's edge and put a sharp point (like a pocket knife tip) on the seam and give it a gentle tap.
    Gentle so as not to break through and damage the coin, but enough to create a gouge. then use this gouge as a lever to pry the halves apart as described by AUandAG.

    Some coins are just plain "Interesting"
  • Options
    DIMEMANDIMEMAN Posts: 22,403 ✭✭✭✭✭

    Table saw!

  • Options
    TopographicOceansTopographicOceans Posts: 6,535 ✭✭✭✭

    I've used flat edge screwdrivers.
    You can also take a pair of scissors to cut around the coins

  • Options
    TurboSnailTurboSnail Posts: 1,669 ✭✭✭✭✭

    the mini screw driver for glasses is safer.

  • Options
    abcde12345abcde12345 Posts: 3,404 ✭✭✭✭✭

    Will pcgs pop those out of the capsules for grading? If not, don't send them in that way.

  • Options
    ChrisH821ChrisH821 Posts: 7,141 ✭✭✭✭✭

    Skin heals, coins don't :wink:

    Collector, occasional seller

  • Options
    thebeavthebeav Posts: 4,111 ✭✭✭✭✭

    I've used single-edge razor blades for things like this all my life. Yes, I still have all my fingers !

  • Options
    DatentypeDatentype Posts: 1,677 ✭✭✭

    Great ideas - thanks!

  • Options
    rickoricko Posts: 98,724 ✭✭✭✭✭

    Occasionally, I could 'twist' them open.... most of the time, I used a knife, carefully inserted into the separation line, and then gently twisted back and forth, moving the knife edge around the container as it separated. Cheers, RickO

  • Options
    thevolcanogodthevolcanogod Posts: 270 ✭✭✭

    I've opened lots of these and the only time I tried with a knife I ruined 2 coins. These capsules are sonically sealed very tight. Here's the method I use now and has resulted in perfect crackout ever since:

    Find a bench vise and put a towel under it. Wrap the capsul in a thin cloth. Put it in the vise so the coin is being squeezed on the rim (i.e. How you would pick up a coin). Slowly tighten until you hear a soft snap or you feel you're going to damage the coin. Take capsul out, rotate 90 degrees, follow same procedure. Take out, rotate 45 degrees, same thing. Take out, rotate 90 degrees. Same thing. At this point the capsul should have broken apart. Now take a screwdriver and gently pull the halves apart wiggling the tip in the opened seam if there's any resistance left.

  • Options
    1630Boston1630Boston Posts: 14,157 ✭✭✭✭✭

    @thevolcanogod
    I can tell that you have done this many times because you said "Find a bench vise and put a towel under it".
    No one would think of putting the towel under the vice until a coin fell to the floor. :smile:

    Successful transactions with : MICHAELDIXON, Manorcourtman, Bochiman, bolivarshagnasty, AUandAG, onlyroosies, chumley, Weiss, jdimmick, BAJJERFAN, gene1978, TJM965, Smittys, GRANDAM, JTHawaii, mainejoe, softparade, derryb, Ricko

    Bad transactions with : nobody to date

  • Options
    DatentypeDatentype Posts: 1,677 ✭✭✭

    Okay the winner for me is putting the coin on it's side and banging the edge lightly with a hammer while rotating it. They pop open pretty easily.

Leave a Comment

BoldItalicStrikethroughOrdered listUnordered list
Emoji
Image
Align leftAlign centerAlign rightToggle HTML viewToggle full pageToggle lights
Drop image/file