Home U.S. Coin Forum
Options

Lucite encased coins

If someone found a key date or rare variety coin encased as below, is there any method of extracting the coin that wouldnt harm the coin?

image

Comments

  • BroadstruckBroadstruck Posts: 30,497 ✭✭✭✭✭
    Although I haven't done it feel that acetone might melt the lucite like an ice cube... Then again I could be wrong imageimage
    To Err Is Human.... To Collect Err's Is Just Too Much Darn Tootin Fun!
  • BAJJERFANBAJJERFAN Posts: 31,255 ✭✭✭✭✭
    I'd get a small coping saw and cut it out as best/if I could and maybe carefully chisel excess material away, then try the acetone.
    theknowitalltroll;
  • LindeDadLindeDad Posts: 18,766 ✭✭✭✭✭
    Agree on the acetone but think it would be like melting a iceberg very slow and messy.
  • BAJJERFANBAJJERFAN Posts: 31,255 ✭✭✭✭✭


    << <i>Agree on the acetone but think it would be like melting a iceberg very slow and messy. >>



    Not if one used a Soxhlet Extractor.
    theknowitalltroll;
  • rickoricko Posts: 98,724 ✭✭✭✭✭
    Remove as much lucite mechanically as possible - avoid coin damage.... then soak in acetone... will take a while, and might need some fluid changes (keep it sealed to avoid evaporation). Tapping the chunks sharply as the material becomes smaller can result in the release of the coin - great care must be exercised in this endeavor. Final soakings will be necessary to remove all residues. When clean of lucite, final rinses with alcohol and hot water will neutralize any chemical traces remaining. Cheers, RickO
  • WaterSportWaterSport Posts: 6,911 ✭✭✭✭✭
    Wow from that description I think RickO has "Been there-done that!"

    WS
    Proud recipient of the coveted PCGS Forum "You Suck" Award Thursday July 19, 2007 11:33 PM and December 30th, 2011 at 8:50 PM.
  • Alltheabove76Alltheabove76 Posts: 1,520 ✭✭✭✭
    I just googled and found that the melting point of lucite is 320F. Far lower than any metals used in coins. I think you could probably use heat carefully and get it out.
  • SwampboySwampboy Posts: 13,099 ✭✭✭✭✭


    image

    image

    "Inspiration exists, but it has to find you working" Pablo Picasso

  • BroadstruckBroadstruck Posts: 30,497 ✭✭✭✭✭


    << <i>I just googled and found that the melting point of lucite is 320F. Far lower than any metals used in coins. I think you could probably use heat carefully and get it out. >>



    Not sure what's in this block that might be worth all the work involved to free it?

    The other thing you need to take into considerations is that many of the coins entombed in Lucite have been prettied up by polishing so they shine.
    To Err Is Human.... To Collect Err's Is Just Too Much Darn Tootin Fun!
  • MsMorrisineMsMorrisine Posts: 35,666 ✭✭✭✭✭
    I've never done it, but NO HEAT


    listen to ricko.


    also, as mentioned, I have worked with acetone and it and its fumes are highly combustible. be careful.

    Current maintainer of Stone's Master List of Favorite Websites // My BST transactions
  • Alltheabove76Alltheabove76 Posts: 1,520 ✭✭✭✭
    I wasn't referring to the coins in the photo as candidates for removal, it just reminded of a 1909-S BU IHC I saw in lucite once.
  • lcoopielcoopie Posts: 8,873 ✭✭✭✭✭
    i seem to recall freezing the thing, perhaps with liquid nitrogen, then hit it with a hammer

    LCoopie = Les
  • MsMorrisineMsMorrisine Posts: 35,666 ✭✭✭✭✭


    << <i>i seem to recall freezing the thing, perhaps with liquid nitrogen, then hit it with a hammer >>




    at those temps, I'd be afraid the metal would be brittle and break too
    Current maintainer of Stone's Master List of Favorite Websites // My BST transactions
  • tahoe98tahoe98 Posts: 11,388 ✭✭✭

    ...stick in oven at 450 degrees, 20 minutes later pour off lucite into jar for re-cycling.... image
    "government is not reason, it is not eloquence-it is a force! like fire, it is a dangerous servant and a fearful master; never for a moment should it be left to irresponsible action." George Washington
  • Heating the coins will discolor them.

    Alan V. Weinberg writes: "Following advice I received some
    years ago from an unknown numismatist, I have had complete
    success extracting coins & medals from paperweight-size
    Lucite by placing the Lucite object overnight in the
    freezer, then taking it to the garage cement floor , placing
    it down on top of a blanket and hitting the uncovered Lucite
    directly & sharply once or twice with a hammer . The frozen
    cold Lucite shatters and you can extract the coin. I emphasize
    use a blanket because sometimes the coin will go flying when
    you hit the Lucite and you don't want the coin to hit the
    cement and dent. Also wear some sort of glasses so Lucite
    shards don't fly into your eyes. It works!"

Leave a Comment

BoldItalicStrikethroughOrdered listUnordered list
Emoji
Image
Align leftAlign centerAlign rightToggle HTML viewToggle full pageToggle lights
Drop image/file