How would you describe this rotation....

Peaceman · June 4, 2008 9:02AM

Dont deal in them at all.... How should I word the error slab? Thanks.

Bear · June 4, 2008 9:06AM

180 degrees, clockwise.

DorkGirl · June 4, 2008 9:30AM

How many degrees is it off? I think up to 20 is still considered within mint tolorances and is not an error. Unless I'm looking it wrong, it doesn't look rotated enough to me.

mozin · June 4, 2008 9:41AM

Sorry, the rotation is not enough to be of any extra value.

Peaceman · June 8, 2008 6:45AM

Looks like it did go for a small premium....

bigmansam88 · June 8, 2008 6:47AM

<< <i>Looks like it did go for a small premium.... >>

Nah, that's only because it's slabbed

COALPORTER · June 8, 2008 6:54AM

Are rotated dies common for this series ?

LickThoseStamps · June 8, 2008 6:55AM

Wow! That's rotated 335 degrees!

erroid · June 8, 2008 7:12AM

I believe that any rotation, up tp 15 degrees, is considered "within mint tolerances"; with 15-20 degrees being a gray area. Your piece appeaes to be between 20-25 degrees CW and "should"(?) be slabbed as such. I note that the IN is slightly lower than TRVST and that will add to the rotation seen on the rev.

erroid · June 8, 2008 7:15AM

Oops, the "lower" IN(verses TRVST) will subtract from the total rotation; your piece is on the "hairy edge".

How would you describe this rotation....

Comments

Leave a Comment