Options
What Is The Safest Way To Crack Out A Coin From A PCGS Holder?
Coinlearner
Posts: 2,612 ✭✭✭✭✭
Never tried it yet but thinking about wrapping in towel and hitting with hammer or putting in vice.
0
Comments
This is not the bets way but it works for me.
Simply cut the slab in the middle of where the coin is and it splits all the way across. The coin then pulls right out. Never had a problem or scratched a coin. No muss, no fuss, no shavings or dust as with a saw.
Bolt cutters don't work on NGC slabs as they are a different plastic and it doesn't crack like the PCGS plastic does.
GrandAm
<< <i>I use a pair of bolt cutters.
Simply cut the slab in the middle of where the coin is and it splits all the way across. The coin then pulls right out. Never had a problem or scratched a coin. No muss, no fuss, no shavings or dust as with a saw.
Bolt cutters don't work on NGC slabs as they are a different plastic and it doesn't crack like the PCGS plastic does.
GrandAm
For NGC slabs a quick hammer tap on all for sides will break the seal and you can pull the slab into its two pieces no problem.
“In matters of style, swim with the current; in matters of principle, stand like a rock." - Thomas Jefferson
My digital cameo album 1950-64 Cameos - take a look!
Don't try unless you've been shown or are brave. But,
after hitting it on the edges you'll hear a distinct pop. Then
you can literally just hold the slab in the palm of your hand
and lift off the top!
Jerry
Link
Governments can print currency. Only the people can print faith in it — and they’re running low on ink.
<< <i>hacksaw, left to right across the lower part of the label. pops right open afterward. >>
Yup.
A table saw is the quickest and easiest way to go.
If you've got several, you can do a dozen in just a couple of minutes.
Can't beat it!
John Marnard Keynes, The Economic Consequences of the Peace, 1920, page 235ff
<< <i>I use a pair of bolt cutters.
Simply cut the slab in the middle of where the coin is and it splits all the way across. The coin then pulls right out. Never had a problem or scratched a coin. No muss, no fuss, no shavings or dust as with a saw.
Bolt cutters don't work on NGC slabs as they are a different plastic and it doesn't crack like the PCGS plastic does. >>
I think you have the same bolt cutters that I do! They do work on NGC slabs, but because the plastic is softer, the bolt cutters wind up scoring the plastic so you can just snap in half cleanly at the score.
60 years into this hobby and I'm still working on my Lincoln set!
I've been told I tolerate fools poorly...that may explain things if I have a problem with you. Current ebay items - Nothing at the moment
Worry is the interest you pay on a debt you may not owe.
"Paper money eventually returns to its intrinsic value---zero."----Voltaire
"Everything you say should be true, but not everything true should be said."----Voltaire
<< <i>I meant to ask....Does CAC pay a 50¢ bounty for stickers from crackouts? >>
<< <i>I meant to ask....Does CAC pay a 50¢ bounty for stickers from crackouts? >>
Does anyone know if CAC is going to publish a population report like the real grading companies?
Worry is the interest you pay on a debt you may not owe.
"Paper money eventually returns to its intrinsic value---zero."----Voltaire
"Everything you say should be true, but not everything true should be said."----Voltaire
Personally, I just whack the top of the slab with a Hammer - w/ safety glasses on, and then carefully finish the job with the screwdriver.