Options
1876-S Dime with very deep mintmark. Anyone have one to show?
RogerB
Posts: 8,852 ✭✭✭✭✭
This letter is self explanatory. Any seated dime specialists have an example to share?
Robert Jefferson was the employee who did most of the mint mark punching. He was often referred to as "Jeff."
1
Comments
There are lots of photos on Gerry Fortin's site:
http://www.seateddimevarieties.com/date_mintmark/1876svarpage.htm
The "small filled S" may look a little less clear than the "small block S".
However, I'm not sure I could call any of the few I looked at "so deep".
I'm not familiar with any "S" MM that looks like an "8".
The letter does not mention the S being filled, so can we presume the S is clearly defined but nearly closed?
I have a couple examples.
The bottom one could conceivably be mistaken for an 8, but I don't see how the blobby one could.
Agree. A little squinting and the S looks distinctly "8-ish." Here's a slightly enhanced version, which might help:
Remember the flap about the 1873 "Close 3" (or Closed 3 as some people say) coins? I as a numismatist was never fooled into thinking them as an "8," but some people apparently were.
Seems like mint marks are more affected by die chips and other crowding issues. Sometimes we must magnify to see clearly. Peace Roy
BST: endeavor1967, synchr, kliao, Outhaul, Donttellthewife, U1Chicago, ajaan, mCarney1173, SurfinHi, MWallace, Sandman70gt, mustanggt, Pittstate03, Lazybones, Walkerguy21D, coinandcurrency242 , thebigeng, Collectorcoins, JimTyler, USMarine6, Elkevvo, Coll3ctor, Yorkshireman, CUKevin, ranshdow, CoinHunter4, bennybravo, Centsearcher, braddick, Windycity, ZoidMeister, mirabela, JJM, RichURich, Bullsitter, jmski52, LukeMarshall, coinsarefun, MichaelDixon, NickPatton, ProfLiz, Twobitcollector,Jesbroken oih82w8, DCW
The volume of steel that must be moved is large compared to the area of the mintmark. This would be especially problematic when dealing with a small curved S or maybe a D. (The recess that many Peace dollar mintmarks seems to sit in, was caused by upward displacement of die steel that was no polished off the die.)