Registered Mail packing questions

First of all, is it best to cover the whole entire box with brown tape? When I sent a package before, the USPS person used their brown tape but only around the edges.
Second of all, what is the absolute most secure tape to use? I found this stuff but I think it's weird and annoying that all of it seems to be water activated instead of pre-stickied? Anyone find better stuff?
Second of all, what is the absolute most secure tape to use? I found this stuff but I think it's weird and annoying that all of it seems to be water activated instead of pre-stickied? Anyone find better stuff?
Early American Copper, Bust and Seated.
0
Comments
-Paul
Basically, the reinforced tape that requires wetting is FAR better than the other options.
If its a few grand, I usually just tape the edges and seams, but if its higher dollar, I cover the box over completely
jim
<< <i>Water-activated is by far the best. It sticks much better, is the only kind I've seen that is reinforced, and because it isn't sticky to start with, the no-gummed side is just paper, which means it accepts ink easily. This is important if you have to write an address over the tape or when they postmark over the seals. Often, the packages I receive with the pre-stickied tape have had all the postmark ink on the stamps rubbed off, which takes away some of the security.
Basically, the reinforced tape that requires wetting is FAR better than the other options. >>
This. I buy my tape, similar to that in the OP, from staples. Ironically, most post offices don't sell it.
All registered mail goes either first class registered (under 13 oz.) or priority registered (over 13 oz or if requested for under 13 oz shipmentsd). It all travels the same snail pace so don't pay extra for priority unless you are over the 13 oz. limit. Don't forget if your registered shipment is over 13 oz. and going the required priority registered you can use priority boxes/lables and take advantage of flat rate priority box shipping discount. Of course they will add the "registered" fee and insurance to that just as they do with "first class" registered. First class registered is always a bit cheaper than priority registered.
USPS requires registered tape to be paper so that postmark won't rub off (no plastic tape). Only requirement is that all seams on box be covered. If necessary on a heavy shipment I will first run a band of half inch reinforced clear tape around it and then cover that with the paper tape.
Another tip. Instead of "signature confirmation" (that requires a post office form) verbally request "electronic return receipt" while at the counter. This requires no form, provides on-line verification of actual signature of the receiver (PDF file that is requested from the usps tracking page) and satisfies ebay and paypal tracking requirements for "signature confirmation." The only gurantee with registered tracking is that post office receipt and delivery will be promptly updated. Scans in between are unpredictable and sometimes non existent.
No Way Out: Stimulus and Money Printing Are the Only Path Left
<< <i>First of all, is it best to cover the whole entire box with brown tape? When I sent a package before, the USPS person used their brown tape but only around the edges.
Second of all, what is the absolute most secure tape to use? I found this stuff but I think it's weird and annoying that all of it seems to be water activated instead of pre-stickied? Anyone find better stuff? >>
The stuff in your link is the best tape to use. You can buy it at Staples for less than that Amazon price. You only need to cover any seams or anything written or stamped on the box that you wish to cover up. If you only do a package infrequently, wetting it under a little faucet water is fine. If you do a lot of packages, there are manual and electric powered dispensers that you can buy which cut the tape and wet it for you. Also registered mail gets handled with kid gloves so you don't need to tape it Fort Knox tight.
If you use the Flat Rate boxes from the USPS, you aren't supposed to cover the words "FLAT RATE BOX".
This is perfect for the job, have used it for years. You don't need a dispenser, just cut to length and wet the back with a sponge or cloth unless of course you are a heavy spitter.
No Way Out: Stimulus and Money Printing Are the Only Path Left
<< <i>Paper tape at Staples - $10.99
This is perfect for the job, have used it for years. You don't need a dispenser, just cut to length and wet the back with a sponge or washcloth. >>
+1,000
The place I used to work was one of the largest package shippers in Iowa and they bought that tape by the pallet-ful. The auto dispensers were really nice.
<< <i>Brown tape only has to cover the edges. Personally I prefer the gummed, water activated tape compared to the self adhesive, it sticks much better.
-Paul >>
What Paul Said
I use it all the time,,,,, no problems,,,
Self Adhesive tape
GrandAm
So that stuff in the link in my first post wrapped several layers entirely around a box would be the best bet? Maybe a white address label over the top?
Could any of you maybe post an example pic of one of your Registered packages all wrapped up?
Early American Copper, Bust and Seated.
Since I have only TPG coins, I put the coins inside a PCGS box, with any padding that seems needed. I use heavy plastic tape in two places to hold the lid on. The USPS Flat Rate Middle Size 11X9X6 inch boxes are generally cheaper for me than smaller boxes. This is a good place to get rid of some of that big bubble packing material, or even popcorn. My PCGS boxes are wrapped in bubble wrap before they are placed inside the big box. I use the Staples tape only on the edges, doing the ends first, then all around the center of the box. My return address gets written on the tape.
I receive so many of the oversized shirt boxes, the ones about 14 inch by 12 inch by 3 1/2 inch, from USPS, and other carriers, that come way too smashed for my liking. I will not use them.
I tried the self adhesive tape and not only is it a lot more expensive, but I nearly made an enemy of my favorite postal clerk. Turns out the self adhesive tape I used was not very compatible with the ink stamp they use to stamp the seams. The ink tended to sit on the surface and not soak in - this resulted in smears and lots of ink transferred to the clerk's hands. I vowed never to use the self adhesive again and pitched it.
“In matters of style, swim with the current; in matters of principle, stand like a rock." - Thomas Jefferson
My digital cameo album 1950-64 Cameos - take a look!
<< <i>Ok interesting. I was thinking about how to package something that absolutely MAXIMUM security...for something that just can't get lost/messed with.
So that stuff in the link in my first post wrapped several layers entirely around a box would be the best bet? Maybe a white address label over the top?
Could any of you maybe post an example pic of one of your Registered packages all wrapped up? >>
Putting a ton of tape on it won't help against theft. Just cover the seams and go registered. You can get 5 or 6 rolls of silver eagles into one of these little suckers.
Here is a small flat rate box about half done. just do the other end to match. Cover the sealable flap too.
Nowadays, I just ask the clerk to tear off a length of their acceptable registered tape. I don't send registered packages often, and this provides me with a free source of guaranteed acceptable tape.
http://www.shieldnickels.net
I buy my packing tape in bulk from ULine and use it for everything.