trying to get some advice for grading 75 raw minis

jivan

[URL=http://s26.photobucket.com/albums I had posted pics to photobucket and was trying to post some pics....buying/have dome raw 75 minis that i need a psa 7 on and need some advice .....all my cards have been purchased already graded, so am a bit clueless...... thanks, ivan...evidentally i did not master this action..sorry

Dboneesq

Ivan ... The link you have listed:

http://s26.photobucket.com/albums

just brings you to the main photobucket page ... not to anyone's page.

psychump

Looking for dome 75 mini's.

purduepete

About the easiest way to explain it is like this: compare your raw Minis with cards of yours that have already been graded PSA 7.

If your raw cards show the same amount of corner wear or off-centeredness (is that even a real word ) like your PSA 7's do, then you should expect to get 7's on your raw cards.

I would also recommend to measure any red/yellow or green/yellow color combo cards 1st before you send them in. Like others here have said, Minis should be 80mm tall - and those two color combos are notorious for being cut short from the factory.

If the cards you are looking to sub are less than 80mm tall, I wouldn't bother sending them in because PSA has been brutal lately about rejecting cards less than 80mm (MIN SIZE REQ).

Hope this helps & good luck with your sub!

jivan

thanks so much... always read the mini threads but i guess until you do it yourself with hands on cards, it's a diff. world...going thru all cards and going to measure.. i found a rule that measures up to 100 ths and measured all graded cards and will use that to guide my raw...ivan

jeff8877

jivan,

It is a lot easier than measureing every card to just find one that you know is full sized and then hold it up vertically on a flat surface next to a bunch of others...the short ones stand right out. Good luck with your sub.

Jeff