This card isn't trimmed, is it?

mmync

I can't imagine why you would trim a card if it was going to end up this o/c, but just wanted to make sure.

JeremyDie1

From the scan I would say no. Do you have the card in hand?

mmync

Yes

JeremyDie1

A trimmed or sanded card will be flat and/or smooth in one or more spots, this is the most common indicator. Lightly run you finger along the suspected edge, if trimmed it will feel much more smooth than the other sides. If possible, check another card in case all four edges have been trimmed.
Look at all the edges and corners of the card under a halogen light and a 10x jewelers loupe. A normal vintage card will be slightly toned (light brown), a trimmed card will magically reveal a very white appearance compared to a naturally toned edge when held under a halogen light. Crimped edges and corners are another thing to look for. Edges and corners are pushed down by the initial cut, this is where the most pressure is applied. Since most cuts are made with scissors, scalpels or razor blades, a cut card will almost always show signs of tampering. Again, a halogen light and loupe should tell all.
When under magnification or a loupe obvious (missed) cut marks or stray hair-like paper strands left over from the cutting utensil may be visible. With the card lying on a flat surface, look at both the front and back. Some trimmed cards may have wavy or uneven edges or have a slant cut or flared corners that are ever so slightly higher than the middle edge. This is usually generated from the person cutting the card with scissors. Taking measurements of the card with a ruler will help to see if its the right size.