Options
What is this on old copper edges?
sinin1
Posts: 7,500 ✭
I have some older coppers that have uniform notches on sections of the edge
- they do not correspond to the denticles - is this something that was caused after minting (screwpressing)
or part of the design/manufacture?
or did some enterprising individuals make some punch to uniformly take off a small percentage of each copper?
I brought this over here to see if anyone has better ideas than the US coin forum does
- they do not correspond to the denticles - is this something that was caused after minting (screwpressing)
or part of the design/manufacture?
or did some enterprising individuals make some punch to uniformly take off a small percentage of each copper?
I brought this over here to see if anyone has better ideas than the US coin forum does
0
Comments
FOR SALE Items
reeded edges in US didn't start until 1830's, with a couple exceptions