cracking a slabbed card
cd06
Posts: 12
hi all,
any advice as to how to crack a psa slab or an sgc slab? thanks for your help.
any advice as to how to crack a psa slab or an sgc slab? thanks for your help.
0
Comments
Slab Crackin'
Step 2: Place tip of screwdriver in upper left corner of graded card. Use hammer, and break off the corner. The piece you're looking to break off should be approximately 1/2" inch in size.
Step 3. Repeat for other top corner.
Step 4: Now that both corners are gone, the case is opened and "damaged". The damage to the case should all you to pry the end of the screwdriver inside. You may hear cracking sounds, which is good! Slide the tip of the screwdriver from corner to corner until the two halves of the case break apart.
Step 5: Careful remove card from plastic, and discard trash.
If at any time you think you're too close to the card, pull back. If you damage the card, if your fault for not going slow!
Good luck.