How do I put an active link on the board?

Comments

• Options

  lbcoach20 Posts: 883 ✭✭✭

  May 6, 2010 8:00AM

  Go to reply post and hit the http link button. Type in the address and hit OK. Then type in the text you want to call it and hit OK. That should do the trick.
  
  Scott

  0
• Options

  WeekendHacker Posts: 1,461 ✭✭✭

  May 6, 2010 10:30AM

  1. Copy the link ( as in copy and paste) (if you do not know how to do this: go to the specific page on your browser and copy the address from the address bar)
  
  2. Go to the "Message Text" box (this is where you type in the message you want to post)
  
  3 See the toolbar under the words "message text"?
  
  4. Start typing in your message; when you come to the point where you want to post a link click on the "http" button on the toolbar.
  
  5 A small box will appear; paste the link into the box by right clicking your mouse and pressing paste......click OK
  
  6. Another small box will appear; type in words you would like to use instead of the link ... (suck as "LINK" or “EBay Auctions”)...Click OK
  
  7. Finish your message and post..... (Reply to thread)
  

  0